The most common MOT failure reasons UK drivers meet are lighting and signalling faults, suspension problems, brake defects, tyres, and anything obscuring the driver’s view of the road. Between them these account for the large majority of failures, and most are visible or audible before the car is booked in. A failure is not a judgement on the car’s age. It is a defect graded Dangerous or Major against a published standard.
The categories that fail most often:
- Lighting and signalling
- Suspension
- Brakes
- Tyres
- Driver’s view of the road
- Exhaust emissions
The Three Defect Categories
Everything on the test is graded, and only two grades fail.
Since May 2018 the DVSA grades every defect into one of three categories, and the certificate shows which applied.
- Dangerous. A direct and immediate risk to road safety or a serious environmental impact. The car fails, and it must not be driven away.
- Major. May affect safety, put other road users at risk, or harm the environment. The car fails and needs repair and retest.
- Minor. No significant effect on safety. The car passes, and the defect is recorded.
Advisories sit alongside these. They are not defects yet, but items heading that way, such as a tyre close to the limit or light corrosion. They are a prediction, and worth reading as a to-do list for the next twelve months.
The distinction matters most at the moment you collect the car, because a Dangerous defect means you cannot drive it off the forecourt even with a valid certificate still running. Can you drive with a failed MOT sets out the exceptions.
Lighting & Signalling
The single largest category, and the easiest to prevent.
Lighting makes up a bigger share of failures than any other group, and most of it is a blown bulb nobody checked. The tester covers headlights on dipped and main beam, sidelights, brake lights, indicators, hazards, rear fog, reversing lights and the number plate light.
What fails beyond a dead bulb:
- Headlamp aim set too high or too low.
- A lens cracked, missing or so clouded it scatters the beam.
- Two different colours or brightnesses across a pair.
- Aftermarket HID or LED units in a housing not designed for them.
- A brake light that stays on, or one that does not come on.
Headlamp aim is worth singling out because it cannot be checked from the driver’s seat and is a straightforward Major defect. A car that has carried heavy loads or had suspension work is a likely candidate.
Checking every bulb takes five minutes on a driveway with someone pressing the pedal, and it removes the most likely single cause of a failure.
Suspension
The category drivers can least often check themselves.
Suspension faults cover worn shock absorbers, damaged springs, worn bushes and ball joints, and corrosion of mounting points. Much of it is only visible with the car raised.
The symptoms that point at it:
- Knocking or clonking over bumps and speed humps.
- The car continuing to bounce after a dip rather than settling.
- Uneven tyre wear, particularly on one edge.
- The car sitting visibly lower at one corner.
- Vague steering or a wandering feel at speed.
A broken coil spring is a Major defect, and a fractured spring can cut into a tyre, which is why it sometimes arrives as two failures at once.
Corrosion counts here too. Excessive corrosion within 30cm of a suspension, steering or seatbelt mounting point is a failure in its own right, which is what catches out otherwise sound older cars.
Brakes
Measured rather than judged, which makes this category hard to argue with.
Braking performance is tested on a roller brake tester that measures each wheel individually. The car must achieve a minimum overall braking efficiency, and the imbalance across an axle must stay within a permitted margin.
What fails:
- Pads worn below 1.5mm of friction material.
- Discs significantly and obviously worn.
- Excessive imbalance across an axle.
- Brake fluid leaks, or contaminated fluid.
- A seized or binding caliper.
- A handbrake that will not hold.
Brake imbalance is the one owners rarely anticipate, because a car can feel fine and still measure outside the limit. If it pulls under braking it will almost certainly fail, and car pulls when braking covers why.
Tyres
The category with the clearest number attached.
The legal minimum is 1.6mm of tread depth across the central three-quarters of the breadth and around the entire circumference. Below that is a Major defect, and it is also a separate offence carrying a fine and penalty points per tyre.
Tyres fail for more than tread:
- Cuts longer than 25mm or 10% of section width.
- Bulges, lumps or exposed cord, which are graded Dangerous.
- Incorrect size or speed rating for the vehicle.
- Mixed construction types on the same axle.
- A tyre fouling the body or suspension.
A 20p coin gives a rough check: insert it into the main tread grooves, and if the outer band is visible the tyre is close to the limit. It is an indicator rather than a measurement. The full legal position sits in tyre replacement UK law.
Driver’s View of the Road
A small category that fails a surprising number of cars.
This covers the windscreen, wipers, washers and mirrors. Windscreen damage is assessed by zone: in zone A, the 290mm band directly in the driver’s line of sight, damage over 10mm fails. Elsewhere in the swept area the limit is 40mm.
Wipers that smear, perished blades, a washer system that does not deliver fluid, and a missing or damaged mirror all fail. So does anything obstructing the view, including stickers, large air fresheners and badly placed dash cams.
Topping up the washer bottle is the cheapest MOT preparation there is, and an empty one is a genuine failure.
The Warning Light Nobody Expects
One dashboard lamp fails the test on its own.
An engine malfunction indicator lamp that stays illuminated, or one that does not work at all, is a Major defect. The same applies to the airbag, ABS and electronic stability control warning lights.
Clearing the code on the morning of the test is a worse strategy than fixing the fault. Clearing it resets the readiness monitors, and a car presented before those have completed can be rejected on that basis alone. What the light is actually reporting is covered in check engine light on.
Removing the bulb fails for the same reason as leaving it lit.
What Happens After a Failure
Three things decide the cost, and one of them is where the car stays.
If the car stays at the testing station for repair, the retest is free. If it leaves and comes back within ten working days, a partial retest at reduced or no cost usually applies. Beyond that, a full test is charged again.
A failure with a Dangerous defect means the car cannot legally be driven away at all, even to another garage. A Major failure with the previous certificate still valid leaves a narrow exception for driving to a pre-booked repair appointment, but the car must still be roadworthy.
The detail on timings and charges is in what to do if your MOT fails, and repairs after a failure are handled through MOT failure work so the retest happens on the same site.
Most of this list is found and corrected beforehand during a service, which is why booking the test alongside a service costs less than two separate visits and a retest. Drivers nearer the villages can use MOT in Allington on the same basis. For the preparation checklist rather than the failure list, see common MOT failures.
Frequently Asked Questions
What is the most common MOT failure in the UK?
Lighting and signalling faults, which make up a larger share than any other category. Most are a blown bulb or headlamp aim, both correctable before the test.
Does a Minor defect fail the MOT?
No. Minor defects are recorded on the certificate and the car passes. Only Dangerous and Major defects fail the test.
Can I drive my car away after an MOT failure?
Only if the previous certificate is still valid and no Dangerous defect was recorded. A Dangerous defect means the car must not be driven from the test site.
How long do I have to get a retest?
Leave the car at the station and the retest is free. Return within ten working days and a partial retest applies. After that a full test is charged.
Does an advisory need fixing straight away?
No, an advisory is not a defect. It flags an item heading towards one, so treat it as the shortlist for the next twelve months rather than ignoring it.
AN Tyres is an authorised MOT testing station in Maidstone, and the same workshop carries out the repairs, so a failure does not mean moving the car somewhere else to put it right.
We can book the test alongside a service so the usual failure items are caught before they cost a retest. Call 01622 862151, email info@antyres.net, or bring the car to Square Hill Road, Maidstone, Kent ME15 7TL.
